Researchers Examine Effects of Gas Chemistry in Laser-based Powder Bed Fusion

In ‘Influence of atmosphere on microstructure and nitrogen content in AISI 316L fabricated by laserbased powder bed fusion,’ the researchers take on the challenge of creating parts via laser‐based powder bed fusion (L-PBF) processes while examining the effects of protective gases.

The authors explain that L-PBF is advantageous to many industrial users worldwide—often through the use of metals like stainless steel. While exposure to nitrogen can increase the quality of a structure in a beneficial manner, if the levels are too high, the integrity of the 3D printed structure can be threatened.

Nitrogen ‘pickup’ is used for austenitic stainless steel, an alloy comprised of a crystalline structure. At temperatures of 900 °C there is ‘appreciative capacity’ for nitrogen in a solidified form. Exposure during processing to nitrogen gas not only results in better strength but ductility levels are not affected, and corrosion resistance also increases. When temperatures become too elevated, however, anti-corrosive properties may be negatively transformed.

Previous research has been performed regarding the amounts of porosity that would be caused by the ‘reactivity and solubility’ of nitrogen, as well as other combinations of the following:

• Argon
• Nitrogen
• Helium
• Hydrogen

With most research resulting in the conclusion that both argon and nitrogen promote density, the authors state that their assessments did not include any chemical or structural examination.

“In the present work the influence of the gas atmosphere on the quality of LPBF parts is addressed. To this end, two batches were made: one batch was manufactured in Ar gas; a second batch in N2 gas. The microstructure, microhardness, and nitrogen contents of the powder and the L-PBF parts of are investigated,” state the authors.

Material for the study included AISI 316L stainless steel powder from  LPW Technology with a particle size of (53  ±  15)  µm and a certified composition (in wt %): Fe = Bal., C = 0.020, Si = 0.70, Mn = 0.76, P = 0.008, S = 0.004, Cr = 17.7, Ni = 12.6, Mo = 2.32, Cu = 0.02, N = 0.09, O = 0.02. The team used fresh powder each time.

 

During the experiment, the team noted that the nitrogen content was reduced to (0.086 ± 0.007) wt %. They stated that this indicated desorption of nitrogen from the molten powder during the L‐PBF‐Ar process and could also cause loss of nitrogen.

“The microstructure of both L-PBF 316L specimens was fully austenitic, with a cellular structure. The specimen manufactured in Ar had a more heterogeneous structure, possibly associated with an increased heterogeneous nitrogen distribution,” concluded the researchers.

“Nitrogen has a paramount importance in the alloying of stainless steel, as even minor changes will have a major impact on the mechanical and electrochemical properties. Future works will therefore focus on the influence of powder reuse with regard to nitrogen content and establishing a method for choosing the atmosphere chemistry in which the nitrogen content in the printed part is controlled.”

Laser-based powder bed fusion techniques are popular in the 3D printing and AM arena today, leaving many researchers and engineers to delve into the science of materials, chemicals, and often, metals—including studies into fault detection processes, metal alloys, and even studies regarding the prediction of mechanical performance. [Source / Images: ‘Influence of atmosphere on microstructure and nitrogen content in AISI 316L fabricated by laserbased powder bed fusion’]