In the past, we have covered various stories concerning a brilliant man named Steve Wood. Wood, who is the founder of Gyrobot, has a very keen interest in working with flexible materials. At the same time, he also has been focusing quite a lot of his attention on creating new designs and methods of printing prosthetic hands for children in need. These two interests led him to develop a new micro extruder to go along with the E3D Cyclops Hotend on his 3D printer. With this extruder, he has found a method of 3D printing both flexible and rigid filaments within the same layers of a print. One of these tests came in the form of a little project he refers to as Flesh and Bones.
“‘Flesh and Bones’ is something I have been thinking about and pondering for a while due to my work on the Filaflex Remixes of the Flexy-Hands (3d printed prosthetic hand),” Wood tells 3DPrint.com. “I want to create a hand that is soft and tactile to touch and yet rigid enough to not collapse in an unorthodox manner. So my remit was to be able to print something that is both soft and hard in the same print in the same layer.”
This is exactly what “Flesh and Bones” was able to do. It proved Wood’s extruder capable of doing exactly what he set out to do. Using his 3-year-old RepRap style 3D printer, which is referred to as a Orca 0.43, Wood upgraded it with the new E3D Cyclops hotend which comes with dual filament inputs, yet only one nozzle for output. It has the ability to switch between these two filaments rather quickly. However, Wood still needed to overcome another issue if he were to attempt to 3D print with both flexible and rigid filaments within single layers.
“The second issue to overcome is that of extruder types for the Cyclops hot end, whilst a dual Bowden system is the most common for this use when using rigid filaments, it is pretty useless for Filaflex which is super soft,” Wood tells us. “There is just too much compression inside the Bowden feed tube. I therefore chose a dual direct drive approach incase I ever wanted to print with two different coloured flexible filaments at the same time. I modified an existing dual extruder design of mine to allow the Cyclops hot end to be fitted. This design, relative to other duals, is very small, lightweight and also easily printed.”
In addition to Wood’s modified hotend, he also needed to make changes to the slicing aspects for the objects he wished to print. He needed to create a program which would allow the Cyclops hot end to purge old material out of the chamber and then push through the new material for each color change.
“Whilst the Cylcops changes colour very quickly, it is not instant,” explains Wood. “Cura has a facility to print a small sacrificial cube to the side of your print, the area of which is editable. During a colour change, the printer prints a layer of this cube using the new colour, thus purging out the old colour before moving back on to the print again.”
Next Wood would like to try out what he refers to as “pseudo material mixing using his hotend.
“I say pseudo because it is not a mixing hot end which can create a truly homogeneous material, but by using one flexible and one rigid filament input and extruding both at the same time then a stripy toothpaste effect will ensue,” Wood explains. “I would like to see using different ratios of input materials and the flow rate of each independently controlled how the properties are affected. Last year I created a piece of software called a Gcode Filament Mixer which would help me in this task. Multiple density and flexibility zones within the same print should be possible, both a designers dream and nightmare at the same time.”
What do you think about the potential that Wood’s methods of printing will provide? Discuss in the Mixing Flexible and Rigid Filaments Within Layers forum thread on 3DPB.com.