Now, there is a new kid on the block, in the form of a cute little boat called #3DBenchy. Released by Creative Tools, 3DBenchy is a cute little boat designed for the specific purpose of testing and benchmarking 3D printers.
“It is a recognizable object that you can download for free, make and share,” says the company. “It is small, 3D-prints quickly. A perfect tool for calibrating your 3D printer.”
Anyone can download the STL file now on Thingiverse and print this little boat out in just about an hour. Once the file has been downloaded, Creative Tools recommends printing it out with the following settings:
- Scale: 1:1 (60.00 mm in length).
- Layer height: 0.2 mm
- Infill density: 10%
- Print speed (extrusion): up to 50 mm/s / (travel): up to 150 mm/s
- Print nozzle diameter: 0.4 mm
- Bridge roof length – The front and rear surfaces should run parallel for a distance of 23mm.
- Chimney roundness – The hole in the middle should measure 3mm in diameter, while the outer top part should measure 7mm, and the depth of the hole should be 11mm.
- Length of the boat – The length of the boat should measure 60mm.
- Width of the boat – The width should measure 31mm.
- Height of the boat – The height should measure 48mm from the very top to very botom and 15.5mm from the bottom of the boat to the top of the cargo box in its stern (rear).
- Cargo box size – The box should measure 12 x 10.81mm on the exterior and 8 x 7mm on the interior, with a depth of 9mm.
- Hawsepipe diameter – The internal diameter of the hawsepipe should measure 4mm with a depth of the flange against the hull of 0.3mm.
- Front window – The front window on the bridge should measure 10.5 x 9.5mm and run parallel to all other inside surfaces of the boat.
- Rear window – The circular rear window on the bridge should measure 9mm in diameter from the inside and 12mm measured from the outer frame, and the flange’s depth should be 0.3mm.
- Bow overhang – The bow of the boat should have a 40 degree overhang, to the x/y axis of the printer. This should be printable on just about all desktop 3D printers.
- Bridge roof – The roof of the bridge should have a 5.5 degree angle slope to the x/y axis.
- Detail nameplate – The #3DBenchy nameplate on the stern of the boat should be readable, extruded at 0.1mm
What do you think? Is this the coolest 3D printable benchmarking tool yet? Have you printed one out? We’d love to see and hear your results in the #3DBenchy forum thread on 3DPB.com. Check out the video below.