Preservation of relics and skeletal collections is a process that is continually being refined with new techniques and technologies. The author expresses grave concern for the safety of skeletal remains, especially after the catastrophes at both the Brazil National Museum and the Notre Dame cathedral—with fires causing great loss.
“Over the next few decades, many skeletal remains from across the globe will be removed from various collections and will then be given back to the claimants or put up where one cannot touch them. This results in fewer supplies that can be utilized for research purposes; therefore, it is necessary to retain information from the remains in as many ways as possible before they wither get returned or worse destroyed.”
In this thesis study, Allen examined 18 different proximal right femoral ends obtained from the Forensic Anthropology Center at Texas State University. Referring to past research in replication of skeletal remains, the author points out that a variety of different materials have been used over the years with good accuracy; in fact, some have been good enough for use in the courtroom even, giving juries the chance to inspect copies of evidence—and providing forensics analysts and labs with a new technological resource on which to rely.
3D technology has added an interesting boost to biological archaeology also, in a range of different exhibits, museums, and learning institutions. One of the greatest benefits today is that museumgoers and other enthusiasts can touch 3D printed replicas without threatening the integrity of items that could be ancient and extremely fragile. Archaeologists and students can also enjoy handling delicate works without endangering them.
The femurs involved in the study were composed of a ‘mixed data set,’ with little deterioration. Allen chose to study this bone regarding 3D printing because so much data can be taken in from this small area. Using calipers and measuring tape, Allen took 11 sets of measurements for each femur in the study, as follows:
- Maximum head diameter
- Anterior-posterior (sagittal) subtrochanteric diameter (M2)
- Medial-lateral (transverse) subtrochanteric diameter (M3)
- Circumference of the head
- Neck circumference
- Superior neck length
- Anterior-posterior neck diameter
- Superior-inferior neck diameter
- Coronal oblique plane/ upper epiphyseal length
- Measurement of the intertrochanteric crest length
- Platymeric Index
“Even if some differences did occur, most likely due to intraobserver error this method does show statistical significance to be able to be utilized for accuracy. However, no constant error rate can be seen during the analysis. Therefore, this method has proved itself to be a useful method for the fields of forensic anthropology not only in terms of presenting to a jury, but also in terms of examination. As for bioarcheology, this method can also be useful in terms of preservation of archaeological remains that are currently on display in many countries around the world,” concluded the author.
What do you think of this news? Let us know your thoughts! Join the discussion of this and other 3D printing topics at 3DPrintBoard.com.