Many things can cause defects in 3D printed parts, including the buildup of residual stress during the printing process. This can be caused by uneven thermal distribution. In a thesis entitled “Control of Thermal Distribution in Additive Manufacturing,” a University of Michigan student named Aniket Chandrashekhar Jadhav attempts to provide a cost-effective solution to uneven thermal distribution through the use of an induction coil to heat the powder, rather than heating the entire bed.
“Controlling the thermal distribution in the powder bed becomes extremely crucial in terms of porosity control, formation of residual stresses, crack initiation, curling, balling and the overall build quality of the parts,” says Jadhav. “Also, significant enhancements in the material properties of the powder metal can be achieved by maintaining constant thermal cycles and temperature profiles throughout the process.”
Jadhav and colleagues used simulation and actual physical trials to test their method of auxiliary heating the substrate to control the thermal distribution and selectively heat the powder. Flux concentrators were used on the induction coils to concentrate and channel the magnetic flux along the desired path and heat the substrate more quickly and effectively. They successfully tested different grades of steel and titanium.
“This ensured minimal changes in operational parameters to easily adapt to substrates with different material properties,” says Jadhav. “The proposed design of the induction coil is small enough to be a convenient addition to any complex environment for improved heating.”
“Work still is in progress to study the effects of induction in translational motion and the required changes that will follow,” Jadhav explains. “These changes may be in terms of coil design modification or process optimization by fine tuning the parameters.”
Induction relies heavily on the coupling efficiency of the coil and substrate, Jadhav continues.
“This study provides good highlight over the improved magnetic flux density and a more contained magnetic field for substrate having a horizontal orientation. A detailed study of the effect of different orientations (e.g.: vertically orienting the substrate) on the coupling efficiency and thermal distribution would play an important role in applying the proposed technique to any Additive Manufacturing process.”
Jadhav also suggests trying different types of induction coils to optimize the process of induction and improve the efficiency of the system, with relatively lower power requirements.
Discuss this and other 3D printing topics at 3DPrintBoard.com or share your thoughts in the comments below.