Now, the company has hit another milestone – Siemens announced that it has 3D printed and engine tested a dry low emission (DLE) pre-mixer for its industrial SGT-A05 aeroderivative gas turbine; 3D printing was also used to improve aerodynamic development testing for this particular turbine last month.
The results of this 3D printed combustion component show that it could help significantly lower CO emissions, and numerous other achievements have also resulted from using 3D printing to fabricate this specific component. Complexity in the production process is simplified, and the geometry of the component was improved upon, which led to a better fuel-air mix. In addition, 3D printing the DLE pre-mixer helped to decrease external dependencies in the supply chain.“This is another excellent example of how additive manufacturing is revolutionizing our industry, delivering measurable benefits and real value to our customers, particularly as they look to further reduce emissions to meet environmental target. Our achievements using AM are paving the way for greater agility in the design, manufacturing and maintenance of power generation components,” said Vladimir Navrotsky, Chief Technology Officer for Siemens Power Generation Services, Distributed Generation.
First, the development of the component only took seven months from start to finish – this is a pretty impressive timeframe for a complex, high-temperature component with tight tolerances that works with high loads. When made with traditional manufacturing processes, the DLE pre-mixer has over 20 parts, but this was reduced down to only two parts by 3D printing the component out of Siemens’ qualified nickel super alloys; this also helped lower the lead time by about 70%.
Douglas Willham, Siemens Director of Engineering for the SGT-A05, said, “And now, with AM technology we have an opportunity to go even further with emissions reduction for DLE combustion.”
The 3D printed DLE solution for Siemens’ SGT-A05 gas turbine uses advanced lean burn combustion technology to reduce emissions, which meant that water injection was not needed; this also helps lower costs. The engine model’s high dynamic loading response is not compromised by applying DLE, evidenced by the fact that over 120 engines successfully use the technology to lower CO and NOx emissions.
The DLE pre-mixer was 3D printed at Siemens’ AM Center of Competence in Sweden. These positive test results further show how committed the company is to moving forward 3D printed serial production of highly complex components in the energy industry.
Discuss this story and other 3D printing topics at 3DPrintBoard.com or share your thoughts in the Facebook comments below.
[Source: Power]