The BEAM, which was launched and attached to the ISS through a partnership between Bigelow Aerospace and NASA’s Advanced Exploration Systems Division (AES), is now halfway through its planned two-year demo on the ISS; this partnership supports NASA’s objective to develop a working human habitat for deep space missions while also growing commercial capabilities for non-government applications.
The BEAM is offering up a lot of useful data on expandable habitats, and shows that soft materials are able to perform just as well in space as rigid ones for habitation volumes. On the ground, NASA and Bigelow are working with the ISS astronauts to monitor the characteristics that relate to the BEAM’s ability to protect humans from the environment of space, such as thermal stability, structural integrity, and the module’s resistance to radiation, microbial growth, and space debris.
Researchers at NASA’s Langley Research Center analyze the data from internal sensors that monitor and locate any external impacts caused by debris, and it seems that the BEAM is performing well, successfully preventing any penetration from orbital debris with its outer protective layers. Now, the focus will move to measuring the radiation dosage inside the BEAM. Thanks to two active Radiation Environment Monitors (REM) inside the BEAM, NASA researchers at the Johnson Space Center can take real-time measurements of Galactic Cosmic Radiation (GCR) levels. While the Earth’s magnetosphere offers the ISS, and the BEAM, a lot of protection from radiation, the researchers are continuing to analyze the radiation to see if the module’s shielding properties can be applied to long-term missions, as future missions in deep space will be more exposed to radiation. In April, a 1.1 mm thick shield was installed onto one of the BEAM’s REM sensors for a multi-month BEAM radiation experiment.The hemispherical white shield was 3D printed by the station crew on the ISS zero-gravity 3D printer. Sometime in the next few months, the crew will 3D print two successively thicker radiation shields, one measuring at 3.3 mm and the other at 10 mm, to replace the existing one. Studying the difference in measurements between the REM with the 3D printed shield and the one without a shield will help researchers “resolve the energy spectra of the trapped radiation particles,” according to NASA.
Since the BEAM was expanded in May of 2016, ISS crew members have entered it nine times, to collect microbial air and surface samples, change out passive radiation badges, and work on the REM shielding experiment. You can read more about the 3D printed radiation shield installation, and some of the other work taking place aboard the ISS, in last month’s NASA Space Station On-Orbit Status update.All of the technology demonstrations taking place aboard the BEAM are helping NASA learn valuable information about expandable space habitat technology in low-Earth orbit; this information could be helpful in planning future human exploration missions. Discuss in the BEAM forum at 3DPB.com.
[Source: NASA]