At the 2015 meeting of the American Chemical Society, Dr. Benjamin Lever introduced research that is being conducted at the Air Force Research Lab at the Wright-Patterson Air Force Base in the area of flexible electronics. The idea being pursued is that flexible semiconductors could be printed directly onto a substrate, such as a flexible polymer-based plastic with the whole contraption being no more than a few nanometers in thickness. The devices would then have anywhere between a 30% stretching limit (comparable to human skin) to a 100% limit (meaning they could be folded). The capacity for stretching would depend on the types of electronics that needed to be included but because of the printing technique, they are nearly always superior to inorganic electronic components. The applications for such a technology are only limited by the imagination. Dr. Lever explained:
“Relatively simply, this is the idea of taking high performance, yet also flexible electronic devices, these could be semiconductors for example, that could be made very thin, just a few nanometers thick so that they are highly flexible, combining those with other components such as batteries or sensors and interconnects that could be printed and putting this combination of devices onto a nontraditional substrate, so this could be a plastic that could be stretchable or conformable.”
One particular application of interest to Dr. Lever is the possibility for creating a patch that could be worn like a bandaid on the shoulder of a member of the Air Force that would be able to collect and transmit information about hydration levels, fatigue, or signs of cognition impairment. That information could be used either by a commander or by the soldier her/himself in order to monitor their overall condition. The applications of these types of devices are not limited to use in military scenarios but could also prove to be extremely useful in medical and consumer applications.
Another area of interest is in the creation of hybrid flexible electronics that are conformable to the shape of aircraft wings or to the inside of an airplane. An ability to print such devices at a minimum thickness would allow for them to
As you can imagine, the survivability of electronic devices under the extreme conditions to which they are regularly submitted as part of both routine and special operations in the Air Force poses a challenge. The creation of a generation of soft electronics could enhance the longevity of important devices that currently suffer damage after exposure to high shock environments such as subjection to 20k – 50k of G-force or introduction into a variety of extreme temperatures. Rigid boards experience failure of the interconnects either through fatigue or by becoming brittle, leading to in-situ failure of components.
Realizing that a weapon, when it hits the ground, experiences approximately 20k g’s of force, it becomes apparent that having electronics that can survive such an impact is vital to continued performance of the weapon and could be truly the difference between life and death for an individual needing to utilize that particular weapon. With traditional electronics, such an impact would cause the components to become violently detached from the circuit board whereas under testing conditions, a flexible circuit on a flexible substrate can survive the same exact conditions.
“There are a lot of applications that the Air Force sees for this. And, of course, all of us who use consumer electronics will also benefit from it, from having electronics that can survive a fall but not having the thick packaging that’s on all our devices now. We could have very thin electronics that could conform to the shape of our bodies but are also very survivable and rugged.”
The video of Dr. Lever’s presentation has been released on youtube and includes a series of questions that he answers which further elaborate on specific applications.