Whether you’re trying to get your home at least partially off-the-grid or are just looking for methods for using less electricity and saving money, Instructables contributor Jeff Heidbrier, of
Heidbrier’s Hero Electronics Wind Turbine HE01 is what is known as a vertical axis wind turbine (VAWT). This particular design capitalizes on urban winds, which tend to come from different directions. It doesn’t have a “tail,” so it doesn’t need to shift position in order to begin spinning. It can be used to generate electric power for tasks like charging batteries or powering small electronic devices. The wind turbine is designed for low speed, so Heidbrier warns against trying to use it in areas of high wind speeds. In fact, it may sound completely counterintuitive, but if you live in an especially windy place or, conversely, a place where there’s little wind on an ongoing basis, you may be better off using solar power as your energy alternative.
This small wind turbine can be constructed using simple hand tools and the 3D printed parts can be printed in either ABS or PLA thermoplastic.
Heidbrier provides a list of materials and electronic components you will need for this project. Note that he warns that “variations in components, tolerances, or construction methods may cause the performance…to differ.” It seems best to go with the items on his list and follow his instructions closely. Here’s the supplies list:
- Stepper motor with 1.4 or 1.8 deg./step, 12 v with 5mm shaft
- Aluminum tubing 7/32 x .014 K&S – 5.56mm x 355mm. K&S stock #1112
- 12” of aluminum tubing 3/16 x .049 K&S stock #3060
- 3’ of aluminum tubing 5.54mm (not needed if you are gluing the blades together)
- 5mm – 3” steel rod
- Black electrical tape
- 3 bamboo or aluminum rods 18” long, 15mm diameter
- 5 M31-10 socket head cap screw with nuts, McMaster-CARR 0.5mm pitch
- Adhesive: hot glue, epoxy of any type
- Hardwood dowel rods diameter .378 x 3, approximately 18” long
Let us know what you think of this bamboo-based turbine in the Urban Wind Turbine forum thread at 3DPB.com.