Today, while records are no longer the preferred method of reproducing sound, as they have been replaced by much higher quality, more reliable digital forms of reproduction, there are still hobbyist and antique collectors who love to listen to their music on the old-fashioned record.
With the advent of 3D printing, there have been some individuals who have taken the modern technology of additive manufacturing and used it to recreate a bit of our past. Back in July, we covered a story on a record that was 3D printed on a Stratasys Objet 500 Connex 3D printer. The sound quality came out quite nicely, although due to the resin it was made with, it was not very useable on typical record players.
One woman from New Zealand, named Oana Croitoru, decided to find out, with her entry into the MakerBot Ghostly Vinyl Challenge. The challenge which asked designers to use vinyl records and turntables as a starting point to design novel objects that would delight record collectors, music lovers and audiophiles, runs until the end of this month, and Croitoru, with her design, has as good of a shot as any to win.
Croitoru decided to design a Hand Cranked Vinyl Player, which is a uniquely designed 3D printed device which can play records by hand.
“All pieces for [the] record player are neatly aligned and designed to fit in a 15x15x15cm cube, and print beautifully on the Replicator 2, without any rafting or supports,” Croitoru wrong. “Once all the pieces are printed, it assembles in about 5 minutes. Then you just add a little glue to make sure nothing flies of as it spins and you’re ready to go.”
In addition to the 3D printed parts and glue, the device also requires a needle for the amplifier, some tape, and a piece of paper. Croitoru’s “deluxe edition” can be created using some small felt squares that are glued to the top of the player, reducing friction, scratching and noise.
The record player is able to play all sorts of records, although Croitoru recommends using 78rpm versions, as others will require a slower crank speed, one which would be very difficult to control. In the video below you can see a demonstration of her device. While the sound quality leaves a lot to be desired, she explains that the version shown in the video is not the latest version currently available on Thingiverse. The latest version should sound quite a bit better.
There are six separate STL files currently available to download on Thingiverse. What do you think? Have you tried 3D printing this record player? How did it sounds? Discuss in the 3D Printed Record Player forum thread on 3DPB.com.