On July 22nd, the heaviest commercial satellite ever launched was sent into space. Weighing in at more than 7,000 kilograms. Telstar 19 Vantage was built by spacecraft manufacturer SSL for Canadian operator Telesat, along with Telstar 18 Vantage, which was launched on September 10th. The two will orbit 36,000 kilometers above Earth and deliver high speed communications services, including broadband Internet, to Asia and the Americas for the next 15 years.
“An analogy is the human eye and the insect compound eye,” said Rob Schwarz, SSL’s acting Chief Technology Officer. “The human eye is one wide view, while the compound eye is like spot beams.”
The spot beams produced by 18V and 19V will focus in slightly different directions, allowing the same spectrum bands to be used multiple times without interference. The satellites will layer both wide beams and spot beams, like a compound contact lens over a human eye.
“There will be a backdrop of broad-area beams, and in high-density areas, we’re adding spot beams to aid coverage,” said Schwarz.
The 18V and 19V satellites use the Ku (12 to 18 gigahertz) and Ka (26 to 40 GHz) bands for both their spot beams and wide beams. These bands have become more popular in recent years because they deliver higher data rates, although they do tend to have higher signal loss in the atmosphere, especially in rainy climates. The 18V and 19V, along with a third satellite called Merah Putih, built by SSL for Telkom Indonesia, are based on the SSL 1300 framework and required specialized antenna arrays, which had to support spot beams in the case of the Telesat satellites.
The Telstar satellites have 3D printed components in the antenna struts, which support antennas, tracking equipment, and satellite control equipment. Using 3D printing for the satellites has a number of advantages: it speeds up production, as well as allowing the production of strong joints with more complex shapes than those allowed by traditional manufacturing. It also cuts down on costs.
Each new communication satellite must spend about 10 days under its own propulsion to reach its final geosynchronous orbit. Once they reach orbit, they deploy their solar arrays and open their antennas. SSL contacts each satellite and runs checks on each system to make sure the equipment is in optimal condition. SSL handles operations for 30 to 40 days before passing the satellites along to their operators. If all goes smoothly, the satellites will operate for 15 years until just before they run out of propellant, at which point they will be boosted to a higher “graveyard” orbit.
“The graveyard orbit is for the good satellites who have completed their operations,” said Schwarz.
Discuss this and other 3D printing topics at 3DPrintBoard.com, or share your thoughts below.
[Source: IEEE Spectrum/Images: SSL]
