As a result, Huber had to mount the rack inboard of the tower by a few inches, which caused a few issues. The bike was slightly harder to load and unload, and the additional distance from the tower caused the crossbars to flex and the bike to move. Also, when two racks were installed, there was additional interference between bikes.
Luckily, Huber had access to PADT’s technological resources. He needed the fairing mount to be inboard a few more inches, so he and the PADT team started by scanning the left fairing mount bracket with a ZEISS Comet L3D Scanner, coating the bracket in talcum powder to make it easier to scan. They then imported the scan file into ANSYS SpaceClaim to use as a template for an editable CAD file.
“The standard mounting bracket is an injection molded part and is hollow with the exception of a couple of ribs,” said Huber. “I made sure to capture all this geometry to carry forward into my redesigned parts, which would make the move to scaled manufacturing of this design easy.”
Huber used SpaceClaim, a direct modeling software, to split the bracket’s two function ends, the crossbar end and fairing end, and offset them by 4.5 inches so that the bike rack could be mounted right at the crossbar tower.
“I used the geometry from the center section CAD to create my offset structure,” he continued. “A mirrored version allows both the driver and passenger side fairing mount to be moved inboard to enable mounting of two bike racks in optimal positions.”
The results were everything that Huber had hoped for. The new fairing mount offset brackets installed just like the factory pieces did, but allowed Huber to install the bike rack right at the tower, eliminating the extra movement and allowing for easier loading and unloading of bikes.
“I am very happy with the end result,” he said. “The new parts assembled perfectly, just as the factory pieces did, and I have increased the functionality of my vehicle yet again.”
If you have a bike rack you’d like to improve, you can find Huber’s files on GrabCAD.
Discuss this and other 3D printing topics at 3DPrintBoard.com, or share your thoughts below.
[Source/Images: PADT]