The SLM process is currently only suitable for copper alloys, but pure copper is more electrically and thermally conductive. Because it reflects up to 90% of laser radiation, only a small bit of the energy is deposited in the material and able to be used for the melting process; system components can also be damaged by the reflected radiation, and the material’s absorptivity for infrared light increases as the copper transitions to a liquid state, causing an unstable remelting process.Daniel Heussen, a research fellow in the Rapid Manufacturing group, explained, “Depending on surface properties, pure copper reflects up to 90 percent of laser radiation in conventionally used wavelengths of 1µm.”
“We are hoping for a more homogeneous melt pool dynamics so that we can build components with high material density and achieve other positive effects, such as a higher detail resolution,” Heussen said of the new SLM approach.
Fraunhofer ILT’s department for laser beam source development is building its own green laser source, in a project dubbed “SLM in green,” because one does not currently exist on the market that meets the boundary conditions of its new process. The immediate goal is to create a high-quality laser, which works with a maximum output of 400 watts in continuous service (cw) with green wavelength (515 nm), for single-mode operation, but the aim for the future is to develop a reliable process for industrial users, in which they can 3D print complex geometries with undercuts and hollow structures using pure copper.
This process could be used to produce small batches of delicate, complex electrical components, efficient heat sinks, and even jewelry.“Inductors for inductive heat treatment in industrial production are excellent showcases for additive manufacturing,” Heussen explained. “They are mostly produced in small numbers with a high level of complexity and a wide range of different variants.”
When it comes to using the new process to make jewelry, the Fraunhofer ILT researchers are hoping to get a much higher detail resolution, and greater cost efficiency in production, than other 3D printing methods, like electron beam melting. The potential even exists for the green laser to work with other non-ferrous and precious metals in the jewelry industry.
Heussen said, “However, before we achieve that, we still need to overcome a few hurdles in process and system development and gain a deeper process understanding for the use of the new wavelength. This is currently the goal of the publicly funded project, which will run until mid-2019.”
An ‘SLM in green’ laboratory setup should be ready by the end of this year. To learn more about Fraunhofer ILT’s new SLM process, visit them in hall 3.0, stand F50, at formnext this fall. Discuss in the Fraunhofer forum at 3DPB.com.