The new combustion chamber NASA tested out recently wasn’t 3D printed (yet), but it was a big step forward from the chamber they had been using for previous tests. Those tests were carried out using an ablative combustion chamber, which erodes when burning, changing internal pressures and only allowing for a ten-second firing time. The newly designed combustion chamber used in the most recent tests was a regeneratively cooled chamber, capable of being fired for much longer.
In the latest tests, the engine was fired for 30 seconds (although it could have gone longer), allowing the engineers at NASA’s Marshall Space Flight Center to obtain, for the first time, information about how the engine’s 3D printed components perform together during a longer-duration burn. With the exception of the new combustion chamber, all of the major components in the test engine were 3D printed, including the fuel injector, fuel turbopump, valves, and more.
The engine they’re working with right now is what’s known as a breadboard engine: the components are connected as they would be during an actual flight, but with an open design that allows the engineers to clearly see each component and to make changes if necessary. They’re hoping to test a breadboard engine next year that’s almost 100 percent 3D printed.“A system is not just a sum of parts put together. It’s a product of the interaction of the parts. What we’re trying to do is understand and manage those interactions,” said Nick Case, lead system analyst for the project. “At the same time, we must understand the performance of the individual 3-D printed pieces. That’s what this test allowed us to do.”
Testing the new combustion chamber with the 3D printed components was crucial because the chamber is where fuel turns to hot gas and provides thrust – 35,000 pounds of it, which is what the engine is designed to produce. In the most recent set of tests, liquid oxygen and liquid hydrogen entered the chamber at around 400° below zero Fahrenheit and exited it at around 6,000°.
“With our new chamber and the longer firings, we are able to create a test environment that is much closer to our design point for this project,” said test lead Andrew Hanks.
While there are no plans to send the demonstrator engine into space, the project will, once completed, show that 3D printed rocket engine components are viable and even preferable to traditionally manufactured ones, and will pave the way for future engines and parts to be fabricated using 3D printing. In addition to developing the next set of 3D printed parts, the engineering team is also working on testing the engine with different propellant combinations, including oxygen and methane. Those two gases are being considered as fuel for deep-space vehicles and landers, as it may be possible to produce them on Mars. You can see a video of the latest test firing below:
Discuss in the NASA forum at 3DPB.com.
[Source: NASA]