Obviously, these combat robots need to be not only serious showstoppers—and with the more special effects the better—but as with any vehicles meant for battle, they must be incredibly strong. And lucky is the team that has built their combat robot with parts from a Markforged 3D printer, known for offering strength first and foremost.
Alex Crease, an applications engineer at Markforged, decided to enter his own creation into the ring, attending the MASSdestruction event at Artisan’s Asylum earlier this month. Crease blogged about his experience, and explained that the Markforged 3D printers are actually used more commonly for combat robotics than you may have imagined—in fact, he describes this as one of their niches. They have sponsored other combat teams in the past too, from creating the robot bodies to 3D printing shock absorbing mounts.
“One of the reasons why our printers are so valuable in this field is due to our high strength to weight ratio,” states Crease. “With continuous strand carbon fiber, our materials can exceed the strength to weight ratio of aluminum, and with the impact resistance of Kevlar, our printers can produce entirely custom parts that can sustain heavy hits no problem.”
Crease had the obvious upper hand with technology, using Onyx with Kevlar reinforcement for the chassis and a 3D printed carbon fiber insert for the center of the weapon disk.
“The spokes of this insert I designed to be upside-down airfoils,” stated Crease. “This means that whenever my weapon is on, the forces from the airfoil help the robot stick to the ground.”
In the first battle, Foiled took on AmbiSinister. And in a very exciting twist, it turned out that this team had also used Markforged 3D printed parts. Sadly for AmbiSinister, however, he was flipped over and ‘spinning like a top’ almost immediately. Not long after that, Foiled had won his first combat experience. Check out the video below and see Foiled win not long after AmbiSinister takes his first major tumble:
He then watched Foiled fight Rising Phoenix and Puppy, ultimately bringing home first place.
Crease points out that this success might not have been possible using parts from another 3D printer with materials more commonly used. Due to the strength and lightweight qualities, he was able to take Foiled right to the top in his first combat event.
“I’m excited to test out future concepts in combat robotics and develop a 3 lb version, Foiled Again!” says Crease.
Are you interested in a Markforged demo? Find out more here. Discuss in the Battle Robot forum at 3DPB.com.
[Source/Images: Markforged]