The latest project from Disney Research, which is often busy with impressive projects involving 3D technologies, involves the creation of 3D printed objects capable of performing gravity-defying feats of balance. Check out this breakdancing teddy bear:
It all comes down to metal balls embedded inside the 3D printed object. The research team, in a paper entitled “Balancing 3D Models with Movable Masses,” describes a 3D design process that includes hollow cavities, or “capsules,” in which the metal balls can be placed during printing. The number and placement of the balls depends on the position or positions the designer wants the object to be able to hold. For example, “Breakdancing Teddy” can hold a total of six stable poses thanks to two strategically placed capsules.
“With embedded movable masses, we have the unique capability to satisfy multiple balancing objectives simultaneously,” the research team explains. “Depending on the pose of the model, the masses will be at different locations, resulting in different centers of mass. With a single center of mass, most objectives would be incompatible. Therefore, we introduce an optimization able to handle a multitude of objectives.”
It’s a delicate, precise design process that involves a lot of careful calculations to ensure that the metal balls roll into the proper positions to create stable centers of gravity. Disney Research, however, wants to create a system that even beginners can take advantage of. With a software system the team is creating, the user would design a model as usual, but also indicate the different ways the object should stand or balance. The algorithms would then use those parameters to add one or more hollow capsules to the design, their shapes, sizes and locations automatically calculated and optimized.
“For fabrication, we rely on fused deposition modeling (FDM),” the team continues. “Many FDM technologies support the fabrication of curvature-bound overhangs without the need for a supporting structure. This enables fabrication of our models with embedded metallic balls without the need for introducing cuts nor relying on a manual assembly after fabrication. We can simply pause the printer, place a ball, and then resume printing. To enable this placement during printing, we need to guarantee that the two end points are at least a radius length apart, leading to additional constraints. For technologies other than FDM, manual cutting and assembly is unavoidable, rendering the above constraints unnecessary.”
“As another interesting direction, we would like to extend our method to design dynamically balanced models,” the research team adds. “Lastly, a design system for the full spacetime control of physical models through optimal conversion between potential and kinetic energy is an interesting but ambitious extension of our work.”
In addition to Disney Researchers Romain Prévost and Moritz Bächer, the paper was also co-authored by Wojciech Jarosz of Dartmouth College and Olga Sorkine-Hornung of ETH Zurich. You can read the full study here. Discuss further in the Disney Researchers Create 3D Prints that Balance forum over at 3DPB.com.
[All images: Disney Research]