For help, he turned to his friends Ryan and David of Eclectical Engineering. The two specialize in both projectiles and wanton destruction in the name of science, so building the world’s largest NERF gun was right up their alley. With an assortment of tools that included everything from PVC pipe to a paintball tank, they set to work – with some help from a 3D printer, of course.
Of course, a giant NERF blaster also requires giant projectiles, so the team cleverly utilized pool noodles and plungers, along with 3D printed adapters and blast caps, to create a series of monster darts that, when fired, exited the blaster at 40mph. They also 3D printed some projectiles that, while lacking the ability to stick to targets like the noodle/plunger darts, were much more aerodynamic and thus traveled much further – up to 130 yards.
Needless to say, the gigantic blaster made the original handheld gun look pitiful in comparison.
“The pressurized air source is a 3000 PSI, 62 cubic inch HPA paintball tank. The air from this tank is immediately reduced to 800 PSI by the regulator at the end of the tank, then again to ~80 PSI by a special low pressure regulator,” Eclectical Engineering explains. “This brings the pressure to (somewhat) reasonable values for launching of normal objects at subsonic, non-relativistic speeds. The pressurized air then feeds up to the first sprinkler valve, which is normally closed. When ready to fill the firing chamber, you simply press the air blowgun attached to this sprinkler valve and the pressurized air gladly fills this region. Now to fire the system you press the air blowgun attached to the other sprinkler valve and BAM. You’re instantly the coolest kid on the block…the cell block.”
While I would think the black powder version of the blaster may fall into the “don’t try this at home” category, you can try building your own giant pneumatic blaster with the full instructions here. Discuss further in the 3D Printed Nerf Gun forum over at 3DPB.com.