The Defense Advanced Research Projects Agency (DARPA) is working on it. In 2013 the agency launched the Vertical Takeoff and Landing Experimental Plane (VTOL X-Plane) project, aimed at developing an aircraft that flies like an airplane but takes off and lands like a helicopter, essentially. It’s been going quite well so far – in March, DARPA selected the prime contractor to work on Phase II of the project, after a several-year design competition that made up Phase I. Aurora Flight Sciences has been developing an experimental VTOL called LightningStrike, in conjunction with partners Honeywell International and Rolls-Royce, and clearly DARPA likes what it sees.
Aurora validated DARPA’s decision on April 18 when they successfully tested a 3D printed scale model of the LightningStrike aircraft. With a wing and canard tail system constructed from carbon fiber and 3D printed thermoplastics, the 20% scale plane only weighs 325 lbs. – a light weight that, without 3D printing, couldn’t have been achieved while maintaining the complex structural elements required.
The April 18 test showed that the scale model of the aircraft can successfully hover, take off and land vertically. Aurora technicians demonstrated the model via remote control as DARPA officials watched.
“The successful subscale aircraft flight was an important and exciting step for Aurora and our customer,” said Tom Clancy, Chief Technology Officer for Aurora. “Our design’s distributed electric propulsion system involves breaking new ground with a flight control system requiring a complex set of control effectors. This first flight is an important initial confirmation that both the flight controls and aerodynamic design are aligning with our design predictions.”
Aurora Flight Sciences has been flying high lately – a few months before winning the contract from DARPA, they made history with the world’s first 3D printed, jet-powered unmanned aerial vehicle (UAV). From here, it looks like things are going to be moving fast. In the next year, Aurora is going to be working on the full-scale version of LightningStrike, with its first test flights scheduled for 2018. That’s an insanely fast progression from original concept to full testing, and 3D printing is largely to thank for that, enabling Aurora to construct the aircraft’s structural elements at, well, the speed of a lightning strike, so to speak. You can watch one of the early test flights below. Discuss in the Aurora 3D Printed Aircraft forum over at 3DPB.com.