Today, the lithophane art form is resurrected with a new twist. 3D printing technologies have replaced the traditional process of hand-carving images in warm wax on a glass plate. In a project documented on Reddit, a 3D printer does the carving, but the overall effect remains the same.
Intending to make a gift for Mother’s Day, Yoter describes the printing process here:
“The first tool printed the lithophane so it appeared as a negative. I didn’t even realize that until I printed it, but kept playing at it until I got results I liked. While printing on the Ultimaker, I was printing on my PrintrBot and slicing in Cura and found a lithophane tool in there I didn’t know existed! I played with it until I got (what I think) was a good result! With plenty of time for Mother’s Day.”
Yoter also reports that he liked an unplanned aspect of his first print: the lithophane’s negative image of a little boy gives off a demonic effect when put against the light. (In fact, one commenter posted that they also 3D printed the image because of this demonic effect.)
The final lithophane, 3D printed using the Cura function, used the following 3D printing guidelines:
“The default 10mm thickness was way too thick for anything I had in hand, so I made it 1.8mm thick after some playing. 10 might work for translucent filament. Printed flat, they looked funny but on edge they looked real nice. Even the funny looking ones backlit okay, which seemed to be the point of the exercise, but they only really look like a person when printed slow and on-edge.”
You can tell by looking at the photos here that the lithophane will make a fine Mother’s Day present, as it captures the child using a timeless technology than spans the centuries from the Chinese Dynasty era to today’s new 3D printed tech era — while maintaining the same intriguing lithophane effects all the while. Discuss in the 3D Printed Mother’s Day Lithophane forum over at 3DPB.com.