This example of a new engine part print job was executed by a Reddit user called “TheRealSpaceTrout,” who took the original design from “hard surface freelance artist” Alec Moody. Moody has worked in the game industry for 14 years, and he co-owns handplane, which develops tools for video game artists. But he also designs 3D printable models, including his “aftermarket” cold air intake system for Miatas made between 1994 and 1997. Cold air intakes are engine modifications, which means they aren’t included in the original vehicle. This modification moves the engine’s air filter outside so that cooler denser air is sucked into the engine; this brings more oxygen, and hence more power, into the combustion chamber.
Here, Moody explains the design, which is open source with available files:
“The design started with a urethane expanding foam pour to capture the availible negative space, that was 3d scanned and I have made about a dozen design iterations over the course of 9 months. I was careful in the design to make smooth transitions between shapes and keep a very consistent cross sectional area at every point of the duct.”
Moody also reports he has only printed the part in ABS, because he states that PLA will “almost definitely melt or deform.” Moody prints everything in multiple sections, and bonds them with ABS cement — “MEK solvent with ABS filler” — which he found in the Home Depot plumbing section.
If you have a Mazda Miata, or know someone who does and would like to add some 3D printed power to the car, you can check out this cold air intake, which proves to be more cost effective and easier to install than other car engine modifications. Discuss in the 3D Printed Cold Air Intake forum over at 3DPB.com.